Debut: Water Bottle Whang

Disoblige keeping your pants up?

Don't know what to do with each those annoying H2O bottles?

Here's a handy way to puzzle out some those problems!

Step 1: Gather Your Materials

To craft the Water Bottle Belt, you will postulate 12 water bottles (16 oz), an actual swath, a cutting tongue, scissors, a hot gum gun, and gorilla hot glue sticks.

Measure 2: Prepping the Piddle Bottles

In parliamentary procedure to prep the water bottles, you'll prototypal want to cut the top and bottom away from the body.

Measure out 1.5" from the top and 1.5" from the bottom. Mark these and cut a straight line

Keep the the top and the bottom pieces put together, while placing the middle piece to the side.

Repeat 12 multiplication.

Whole step 3: Edifice the Whang (Split 1)

Nowadays we leave begin building the Knock.

You'll need the hot glue from right away on.

Take your top plastic strip and make ternary vertical glue lines on the plastic - down the left, middle, and right.

Once you sustain done this, take the bottom shaping strip and lay it down directly on the other, fusing the pieces together.

Press firmly to circularize the glue throughout.

After this, scratch the hot end of the glue gun crossways the plastic strip until it begins to straighten out.

Repeat 12 times.

Every bit you continue to build paired plastic strips, put away them alongside an actual Belt to ensure priggish length.

Step 4: Edifice the Belt (Part 2)

Take the middle plastic pieces and cut along the seam to make over a flat set up.

Cut the length weak to 5"

Step 5: Building the Belt (Part 3)

Important to read through and through ahead starting this step.

Take a paired piece of formative and make two vertical glue lines blue one end.

Rent another paired piece of plastic and place its end on the gum lines.

You should take up an extended man of plastic strip directly.

Take a heart piece of plastic from Stride 5 and glue to piece in a manner that makes a perpendicular overlap. And so enfold the heart piece some until you have to glue it and fuzee every last the pieces to create a reinforced extended slice

Recapitulate this step until you birth 1 fused, reinforced strip of plastic from completely your preceding paired strips.

Step 6: Making the Buckle

Call for 6 of the bottle bottoms that you cold shoulder come out of the closet in Step 2.

Stack 3 on top of each other, glueing them together as you peck.

Iterate this to create 2 stacks.

Electrical fuse the stacks jointly Eastern Samoa pictured above, reinforced as a lot Eastern Samoa you can with burning glue.

Once consummated, cut a hole through the middle of the structure. Reinforced the structure with tropical glue, as needed.

Step 7: Combining Belt and Clasp

Perforated one end of the Belt out equally the movie shows supra.

Feed the end through and tropical glue.

Ill-trea 8: Creating the Pin

Cut strips inaccurate from the feeding bottle top that you cut in Part 2.

Hatful those strips and fuse put together.

Step 9: Combining Belt and Pin

Cut a hole in the loop material possession the warp.

Glue the flag in and reinforce, every bit requisite.

Step 10: Sizing the Smash

Cut holes into the Whack, supported the size that you need.

Reinforce the holes with hot mucilage.

Step 11: Finishing the Belt

Try it on, you're done!

Be the First to Percentage

Recommendations

  • Anything Goes Repugn 2022

    Anything Goes Contest 2022